• IEC 61034, 1 & 2: Measurement of smoke density from cable combustion under specified conditions

- Part 1: Test equipment

- Part 2: Test process and requirements

• BS 6853: General code for fire prevention in the design and construction of passenger carrying trains

• GB/T 17651.1&2: Determination of smoke density from burning of cables and optical cables under specified conditions

Equipment No.:  PX02007

Combustion Chamber Dimension：3000(W)×3000(D)×3000(H)mm

Console Dimension：600(W)×600(D)×1000(H)mm

Power Supply:  AC 220V,10A

Weight:  APPR.100kg

Gas Source:  Distilled water, methanol, toluene, anhydrous ethanol

• The combustion chamber consists of a cubic structure of 3000mm±30mm

  
  

• Smoke collecting hood, smoke exhaust pipe and air valve should be installed in the appropriate position of the combustion chamber, and the smoke in the test chamber should be eliminated after the test

  
  

• Standard light source: power 100W, 12V, luminous flux 2000-3000lm, color temperature 2800-3200K

  
  

• The light source is powered by high-precision voltage regulator, and the voltage display precision is up to 0.001V

  
  

• The light source system can be precisely focused to the nominal cone diameter of 1.5±0.1M

  
  

• Imported optical receiving system; Data stability, accuracy, linear error rate < 1%

  
  

• Equipped with automatic control of the filter correction mechanism, automatic correction of light path, improve the accuracy of testing

  
  

• Equipped with seat type fan, air volume 1-15m3/min to balance the flue gas in the laboratory, potentiometer to adjust the fan speed

  
  

• Alcohol metal plate: bottom 210*110mm, top: 240*140mm, height: 80mm

  
  

• Anhydrous ethanol combustion provides fire source for the sample

  
  

• Stainless steel clip can quickly clip samples of different wire diameters

  
  

• Equipped with precision temperature sensor to collect combustion chamber temperature

  
  

• PC+Labview special software control, display, calculate, store test parameters and test data

  
  

• Program Set the optical path calibration program to meet the calibration requirements of the test